DisplayLink USB Display Adapter Manual do Utilizador descarregar pdf (Página 24)

Public Page 24

DisplayLink Corporate Install Guide

8. Once everything works as expected, it should then be safe to deploy the solution onto the

corporate network.

6.5.2 Rolling out the Driver

To roll out the driver, simply link the GPO to which Computer OU you want to deploy the driver to.

6.5.3 After installation

In order for the DisplayLink-enabled hardware to function properly, a subsequent reboot may be required

after GPSI has installed the DisplayLink software on the end-users machine. This is normal, as installing a

graphics driver under Windows usually requires a reboot, post-installation.

6.6 Uninstalling the MSI installed Drivers

Note: These steps are only supported from v6.1 M1 onwards. Releases before this date cannot be silently

uninstalled.

To uninstall the DisplayLink software, msiexec can be run in quiet mode. The following commands should be

run in the following order:

To uninstall the product:

start /wait msiexec /qn /x \\path\to\Setup.msi DL_PACKAGE_ONLY=Yes

REBOOT=ReallySuppress

To uninstall the DisplayLink Core software:

start /wait msiexec /qn /x \\path\to\DisplayLinkCore.msi REBOOT=ReallySuppress

If the option "REBOOT=ReallySuppress" is not used, the system will automatically reboot without warning

after the uninstall. This is probably not desired behaviour, therefore it is suggested this option is set, and the

PC rebooted by the user later.

Note that it is not possible to uninstall the Core if there are other customer product packages installed.

To remove the DisplayLink software from SCCM:

1. In Software Library \ Overview \ Application Management \ Applications select the application that

needs to be uninstalled. Make sure that Graphics application is selected. In the tab Deployments,

1 2 ... 19 20 21 22 23 24 25 26 27 28

Sem comentários

DisplayLink USB Display Adapter Manual do Utilizador Página 24